Self-locking nylon cable ties wrong processing phenomenon

Due to the particularity of the self-locking nylon cable ties (thin wall, the product injection process is relatively large), its mold, injection process, and material are quite particular. So what is the phenomenon of wrong processing of self-locking nylon cable ties? Let's take a look.

This is the content:

• Early delivery error

• Missing items in the pre-setting of the cable tie parameters in the bill of materials

• The process parameters of the cable tie in the layout diagram are incorrect or the schematic description is ambiguous

• The processor does not understand the schematic diagram and parameters of the cable tie in the matching board diagram

Early delivery error

Chassis assembly and cab assembly produce different types of self-locking nylon cable ties at the same time. Each product uses self-locking nylon cable ties of various specifications. Different wire harnesses use the same specifications of cable ties and also use different specifications. Therefore, when preparing and unloading, it is easy to confuse and send out the cable ties with similar shapes and colors, resulting in the wrong self-locking nylon cable ties flowing into the processing site.

Missing items in the pre-setting of the cable tie parameters in the bill of materials

At present, the BOM output process is complicated. First, the process parameters of self-locking nylon cable ties are extracted from the process drawing to the CAPP system (a process design auxiliary system), and then the BOM is standardized and changed through the CAPP system. The list is imported into the ERP system (an electronic auxiliary system for material storage and product management based on a single product), and the self-locking nylon cable ties process engineer manually adds tapes and other auxiliary materials in the ERP system to complete the final bill of materials output. In this process, there is a risk of losing data imported from the system or missing items manually added auxiliary materials.

The process parameters of the cable tie in the layout diagram are incorrect or the schematic description is ambiguous

For self-locking nylon cable ties with schematic diagrams on the design drawings, there is no clear schematic view direction. For example, a schematic diagram of a cable tie needs to be viewed from front to back but the reference point has not been determined. The self-locking nylon cable ties process engineer did not recognize this risk. Only the original design drawing information is reflected on the layout drawing (product drawing) so the processor cannot correctly identify the schematic information.

The processor does not understand the schematic diagram and parameters of the cable tie in the matching board diagram

The processor cannot accurately understand the information of the process (including the layout drawing, product drawing, and cable tie operation instructions) during the assembly process of self-locking nylon cable ties.

The above is the relevant content about the wrong processing of self-locking nylon cable ties. If you are interested in self-locking nylon cable ties, you can contact us. Our website is https://www.chsplastics.com/. I look forward to your arrival very much and hope to cooperate with you.