Introduction of insulated terminals

An insulated terminal is mainly used to achieve electrical connection so that the wire connection is a more convenient application. For example, two wires need to be connected and disconnected, this situation can be used insulated terminal, play the role of open and close, no need to weld the line, you can ensure that you can pass enough current. The traditional wiring method is faster and more convenient.

Here is the content:

• The use of terminal blocks

• The composition of the terminal

• Characteristics of wire terminals

The use of terminal blocks

Insulated terminals are to facilitate the connection of wires and applications. It is a section of metal sealed inside the insulating plastic. Both ends have holes that can be inserted into the wire. There are screws for fastening or loosening, such as two wires, that sometimes need to connect, and sometimes need to disconnect, then you can use the insulated terminal to connect them, and can be disconnected at any time, without having to weld them together or winding together, very convenient and fast. And suitable for lots of wire interconnection, in the power industry, there are special terminal blocks, terminal boxes, which are full of terminal blocks, single-layer, double-layer, current, voltage, ordinary, breakable, etc. A certain crimping area is to ensure reliable contact, as well as to ensure that sufficient current can be passed.

The composition of the terminal

The composition of the insulated terminal is still relatively simple, it is a section of metal sealed in insulating plastic. There are holes at both ends for inserting wires or screws for fastening or loosening. For example, between two wires. Sometimes they need to be connected, and sometimes they need to be disconnected, and here they can be connected with insulated terminals, instead of soldering them or winding them together.

Characteristics of wire terminals

With the use of existing rail type insulated terminal frame screw connection technology, and the addition of electronic components composed of circuitry, the realization of the photoelectric process transmission coupling.

The core of automatic control is that the control unit must be reliably isolated from each sensor and actuator to avoid interference. The insulated terminal can perform this function well and ensure that the field signal and electronic control device are required by the low voltage match, but also for process control peripherals and control, signal, and regulator devices between the interface components. And for different voltage and power, the photoconductors are suitable for different voltage and power ranges.

The insulated terminal has the advantages of signal loss at the control end, high switching frequency, no mechanical contact jitter, no wear switching, high insulation voltage, not afraid of vibration, not affected by the position and long life, etc., so in the field of automatic control is widely used.

The production of standard insulated terminals is the responsibility of each manufacturer to ensure the safety of electricity and the healthy development of the market. CHS has conducted several tests on the terminal blocks before leaving the factory, and the quality pass rate is guaranteed. If you are in the business of insulated wire, you can consider our cost-effective products.